-40%

Alternator Kit 105mm BMW R Airhead 1974-76 Moto Guzzi 1974-94,EDL1-ALTKIT105

$ 145.93

Availability: 18 in stock
  • Surface Finish: charcoal
  • Refund will be given as: Money back or replacement (buyer's choice)
  • Item must be returned within: 30 Days
  • Manufacturer Part Number: 12 31 1 244 642,12 31 1 243 001,12 31 1 244 062, 0
  • Condition: New
  • Country/Region of Manufacture: Unknown
  • Returns Accepted: Returns Accepted
  • Return shipping will be paid by: Buyer
  • Placement on Vehicle: Front
  • Brand: EnDuraLast
  • Warranty: Yes

    Description

    Euro MotoElectrics . . . Your Source for BMW Motorcycle Parts ! ! !
    Part #: EDL1-ALTKIT105
    Stock Replacement
    EnDuraLast I Alternator Charging System.
    The EnDuraLast I Charging System comes with a 105mm outside diameter stator (timing cover side) and stator frame side outside diameter is 107.5mm to fit BMW R 1974-1976 and Moto Guzzi 1974-1994
    Vehicle Manufacturer:
    BMW R Airhead 2 Valve, Moto Guzzi with Bosch Alternator
    Application:
    BMW R Airhead 2 Valve, Moto Guzzi with Bosch-style Charging System
    Make/Model:
    BMW R Airhead 2 Valve, BMW, BMW R60, R65, R75, R80, R90 1974-1976
    Model Years:
    1974-1976 (BMW) 1969-1994 (Moto Guzzi)
    Manufacturer #:
    BMW Rotor: 12 31 1 244
    642
    (240 watt / 17A ) , 12 31 8 002
    347
    ( 180 watt / 13 A )
    BMW Stator: 12 31 1 243
    001
    BMW Diode Board: 12 31 1 244
    062
    ,
    063
    BMW Voltage Regulator: 12 32 1 244
    409
    Bosch Rotor: 0 124 033 027
    Bosch Stator: Fits Frame Label # 0 120 340 001, 0 120 340 002, 0 120 340 003, 0 120 340 006
    Bosch Diode Board: 0 197 002 001, 0 197 002 002, 0 197 002 003
    Bosch Voltage Regulator: N/A
    Moto Guzzi Rotor: 17712457
    Moto Guzzi Stator: N/A
    Moto Guzzi Diode Board: N/A
    Moto Guzzi Voltage Regulator: 29.70.38.01
    (See APPLICATION TABLE tab to verify vehicle fitment)
    Important Note:
    Measure the inside (timing cover side) and outside (stator frame side) diameter of your stator ring with calipers before ordering.
    Brand :
    EnDuraLast
    View our 19 page color installation guide:
    EnDuraLast I Charging System Installation Guide
    USE OF ODYSSEY BATTERY ( DRY CELL DESIGN) AND LITHIUM IRON BATTERY NOT RECOMMENDED OR SUPPORTED FOR WARRANTY
    You may care to reveiw
    Classic Boxer Charging book
    by
    Rick Jones
    for complete detailes of the finer workings of the BOSCH 3phase charging sytem:
    CBC-Book
    Technical Information:
    View our 19 page color installation guide:
    EnDuraLast I Charging System Installation Guide
    Alternator Rotor
    Designed to replace the original Bosch Rotor with modern EnDuraLast technology
    OEM Iron Claw Poles, ETP Copper Wire, Nylon bobbin, double resin coating for insulation protection.
    Computer balanced for reduced high engine RPM vibration reduction.
    Special resin soaking of coil increases life expectancy at high operating temperatures and engine RPM speed
    Brand New - no core charge , no exchange of your old rotor required.
    Description
    Alternator Rotor NEW
    Voltage
    12 v
    Shaft Length
    83 mm
    Claw Diameter
    73.5 mm
    No of Claws / Splines
    6
    Drive End Diameter
    28 mm
    Slip Ring End Diameter
    32.5 mm
    OHMs
    2.9
    Alternator Stator
    Timing Cover Side OD: 105 mm
    Stator Frame OD: 107.5 mm
    Inside Diameter: 74 mm
    Diode Board / Rectifier - 8 x 60 amp diodes;
    Modern Design and Technology -
    8 x 60 amp diodes
    Stock original design,
    supplied with 12 gauge wiring harness
    Adjustable Voltage Regulator - 14.3 Volts
    14.3 Volts; can be adjusted to higher voltage, comes with voltage regulation adjustment guide... Set at 14.3 Volt trim setting; Adjustable voltage setting allow for optimizing the correct voltage for lower RPM urban operation. Must be used with caution as over charging with higher voltage setting can and will damage a battery. Metal housing electronic voltage regulator.
    Not recommended to exceed 14.5 V.
    Misadjustment will damage electrical components, including battery !
    Comes with voltage trim setting instructions.
    Part # EDL1-ALTKIT105
    Model
    Year
    R50/5 (2476)
    08/69-07/73 ECE
    R60/6 (2476)
    07/73-06/76 ECE
    R60/6 (2476)
    01/74-05/76 USA
    R75/5 (2476)
    08/69-07/80 ECE
    R75/6 (2476)
    09/73-06/76 ECE
    R75/6 (2476)
    01/74-06/76 USA
    R90/6 (2476)
    09/73-06/76 ECE
    R90/6 (2476)
    01/74-06/76 USA
    R90S (2476)
    09/73-06/76 ECE
    R90S (2476)
    01/74-06/76 USA
    Returns: All returns must be in original packaging where applicable and must NOT have been installed. Previously installed parts are NOT returnable. Returns must be in re-sellable condition. Please contact us if you are having problems with any item you have purchased from us.
    Thank you for shopping with Euro MotoElectrics. Your complete satisfaction is our goal. Please contact us if you are not completely satisfied with your purchase, prior to leaving feedback. We will make every effort to ensure complete satisfaction. We appreciate your business. TEAM EME~
    Visit My eBay Store: euro_motoelectrics